【正文】
序號 英文內容 中文解釋 處理方法 1001 MACHINE EMG STOP 機床緊急停止   1002 CNC SYSTEM ALARM 數控系統故障   1003 SERVO DRIVER ALARM 伺服驅動器故障   1011 AXIS X POSITIVE LIMIT ALARM X軸正向硬件限位故障   1012 AXIS X MINUS LIMIT ALARM X軸負向硬件限位故障   1021 AXIS Y POSITIVE LIMIT ALARM Y軸正向硬件限位故障   1022 AXIS Y MINUS LIMIT ALARM Y軸負向硬件限位故障   1031 AXIS Z POSITIVE LIMIT ALARM Z軸正向硬件限位故障   1032 AXIS Z MINUS LIMIT ALARM Z軸負向硬件限位故障   1045 CUTTING_HEAD CABLE CUT 切割頭傳感器斷線報警   1046 CUTTING_HEAD TIP TOUCH 切割頭傳感器碰撞報警   1047 CUTTING_HEAD BODY TOUCH 切割頭傳感器側碰報警   1048 CUTTING_HEAD NOZZLE LOST 切割頭傳感器噴嘴丟失報警   1049 SENSOR AUTO CALIBRATION ERROR 傳感器自動標定錯誤   1053 AIR PRESSURE LOW 空氣壓力低   1054 O₂ PRESSURE LOW 氧氣壓力低   1055 LASER HV FAULT FOUND 激光器高壓故障   1056 EX_CHANGE TABLE INVERTER ALARM 交換工作臺變頻器故障   1057 LUBRICATION OIL LEVEL LOW 潤滑油位低報警   1058 MECHNICAL SHUTTER NOT OPEN 機械光閘未打開報警   1059 MECHNICAL SHUTTER NOT CLOSE 機械光閘未關閉報警   1060 EX_CHANGE TABLE ALARM 交換工作臺故障   1061 Z AXIS FOLLOWING LIMIT ALARM Z軸隨動負限位超出   1062 EJECTOR MOTOR ALARM 排屑馬達故障   1063 FUME MOTOR ALARM 除塵馬達故障   1064 Z AXIS HEIGHT TOO LOW，PLEASE LIFT Z AXIS Z軸位置太低，請提升Z軸   1100 SET LASER POWER PARAMETER ERRORS 設置激光功率超出范圍   1101 SET PARAMETER("P110"or"P120") ERRORS 設置參數“P110”或“P120”錯誤